The Quark Turbo features a larger, deeper reflector for improved throw. The Turbo series operates the same as the tactical subseries: with a significantly different UI than the regular Quarks. This UI allows the user to program both primary and secondary outputs.

Features:

• LED Emitter: Premium Cree XP-G R5
• 5 Current Regulated Output Levels
• 3 Flash modes: Strobe, SOS, Beacon
• Momentary Activation
• Level Memorization
• Square threads for lifetime smooth operation
• Type III Hard Anodized finish
• Reversible/Removable Clip
• Flexible & secure hand grip accessory
• IPX-8 Waterproofing
• Impact-resistant glass lens with Dual-coating
• T-6061 Aircraft-grade Aluminum Body

Output and Runtime:

• Moonlight: 0.2 lumens (30 days)
• Low: 4 lumens (5 days)
• Medium: 22 lumens (30 hrs)
• High: 85 lumens (4.5 hrs)
• Max: 230 lumens (1.8 hrs)
• Strobe: 230 lumens
• Beacon: 0-230 lumens pulse

Operation:

Insert the battery with the positive side (+) towards the head. Make sure the head and tailcap are tightened, then depress the tailcap button fully so that it "clicks" and the light turns on. You can also press the tailcap lightly to activate the light momentarily.

The Quark Tactical can memorize any two modes of output, from its eight total modes, to be instantly available. These two memorized modes are accessed by either tightening or loosening the head (for example, tight can be Max, and loose can be Low).

Programming Modes:

To have your Quark Tactical memorize a different mode, turn it on and loosen the head by a half-turn. Then, tighten the head at least four times rapidly (twisting it tight, then loose, then tight, etc., four times). After the fourth time, leave the head tight or loose depending which position you want to program.

After three seconds, the light will flash, signaling it is ready to be programmed. Cycle through the eight available modes by clicking the tailcap off and on. The mode sequence is as follows:

Moonlight » Low » Medium » High » Max » SOS » Strobe » Beacon 

Once you find your desired mode, leave that mode on for ten seconds and the light will flash again, confirming that the mode has been memorized. To cancel programming before it flashes, turn the light off for three seconds.